undefined  
DR. BABASAHEB AMBEDKAR TECHNOLOGICAL UNIVERSITY, LONERE –  
RAIGAD -402 103  
End Semester Examination – May 2019  
-
--------------------------------------------------------------------------------------------------------------  
Course:  
B. Tech (All)  
Semester: I/II  
Subject:  
Date:  
Engineering Graphics (EG1203)  
23/05/2019 Marks: 60  
Time: 4 Hrs.  
=
===============================================================  
Instructions to the Students  
1
2
3
4
. Each question carries 12 marks.  
. Attempt any five questions out of the following six questions.  
. Illustrate your answers with neat sketches, diagram etc., wherever necessary.  
. If some part or parameter or dimension is noticed to be missing, you may  
appropriately assume it and should mention it clearly  
_
____________________________________________________________________  
(Marks)  
Q.1 a) Draw the following types of lines according to drawing standard SP 46. (6)  
1
2
3
4
5
6
. Cutting plane line  
. Centre line  
. Hidden line  
. Dimension line  
. Extension line  
. Outline  
b) Draw a regular hexagon of 30 mm side by any method and draw also a circle  
touching each corner of the hexagon. (6)  
Q.2 Draw the following views of the object (in X – direction) shown below, by using first  
angle projection method.  
a) Front View (4)  
b) Top View (4)  
c) Right Hand Side View (4)  
Page 1 of 3  
A10D47D351C36413541E38D94294889B  
undefined  
Q.3. Draw the projections of a regular hexagon of 25 mm side, having one of its sides in  
the H.P. and inclined at 60° to the V.P., and its surface making an angle of 45° with  
the H.P. (12)  
OR  
A line PQ 100 mm long is inclined at 30° to the H.P. and at 45° to the V.P. Its mid-  
point is in the V.P. and 20 mm above the H.P. Draw its projections, if its end P is in  
the third quadrant and Q in the first quadrant. (12)  
Q.4 Draw the projections of a pentagonal prism, base 25 mm side and axis 50 mm long,  
0
resting on one of its rectangular faces on the H.P. with the axis inclined at 45 to the  
V.P. (12)  
Q.5. A cone, base 75 mm diameter and axis 80 mm long is resting on its base on the H.P.  
It is cut by a section plane perpendicular to the V.P., inclined at 45° to the H.P. and  
cutting the axis at a point 35 mm from the apex. Draw its front view, sectional top  
view, and sectional side view. (12)  
Page 2 of 3  
A10D47D351C36413541E38D94294889B  
undefined  
A10D47D351C36413541E38D94294889B